E, ovako treba... > Aluminiumski čamci

Alu Angler

<< < (4/8) > >>

LSI:
Welcome, dear Ufling.

It is nice that you have decided to join us and it is even better that you are willing to share with us your knowledge and experience.

Shortly about our posts regarding your construction and your boat:
Generally, comments were appraisals for your work and compliments to design.
There were also a few comments regarding the technique and equipment you have used during construction and assembling.

The rest were comments and jokes between members of our forum regarding our real chances to build such a boat. For most of us this design will remain something we only can dream about.

Kapetan:
Hi Uffe ,
welcome to our forum , i have translated some of posts (in red ) so u can read what we have writen abaout boat , also if there is any new postings i will traslate to english or serbian :)

And now a question from me:) what is thiknes of aluminum for the hull ? and wath for the ribs ?

Pozdrav Uffe
Dobrodosao na forum, preveo sam neke postove (crevno) tako da mozes a porcitas sta smo pricali o tvom camcu. Takodje ako bude jos nekih novih postova ja cu ih prevesti :)

A sad jedno pitanje od mene , koja je debljina aluminijuma na koritu , a koja na egijama ?

ko zna neka odmah svoj post prevede na engleski a ja cu za one koji ne znau engleski prevoditi ...

mossi:
Welcome Ufling! 

---------------------

Kapetane, Dno je od 5mm, stranice i unutrašnja konstrukcija 4mm.  :good:

AlMg3% ?

SALE NB:
Upotrebljen je AlMg4,5Mn sa trgovačkom oznakom AW 5083
Piše gore , na prvoj slici! :good:

[color=]They were using AlMg4,5Mn, usually marked as  AW5083 .
You have it up there, on picture No1![/color]

mossi:
Znači tvdo do bola! Pomalo krto, ali pretpostavljam da je sve majstorski odradjeno i po projektu!  :good:

Inače u Aluminijum se dodaje od 0.5 - 5% Mg, što ga ima više, tvđi je i krući!
"Moj" je taban od 3mm AlMg3%

Navigacija

[0] Indeks poruka

[#] Sledeća strana

[*] Prethodna strana