E, ovako treba... > Majstorije i popravke - Uradi sam..

Grejanje na brodu-resenja

<< < (2/48) > >>

HOGAR:
Dedo bre,pa jel se ljudi greju samo na plin  :smile:,a vidis da se neki i plase :superstition:.A recimo uljni radijator manje snage,pa inverter,pa cepaj,pa jos drugi nacini,aman :smile:

deda:
Gle ovako vikinze!!Recimo , kod mene na camcu ima mesta jos za flasu vode!Di da turim (da prostis) radijator , ili pec na drva!Ono , drva su najlepsa , jos pec sa prozorom!!! :yahoo: Znaci , ne postoji univerzalno resenje , nego po mogucnostima novcanika i ladje!! :taunt:


Mislim , pogledaj ovo , sta god da izaberes neces pogresiti!!Samo , cene sitnica!!!

http://www.marinestove.com/index.htm

deda:

--- Citat: maverick  24, 10, 2011, 17:17:53 posle podne ---uzeo sam webasto air top 2000, da li moze biti namontirano u otvorenom dijelu camca, da li mu smeta kisa i vlaga s obzirom da ima elektroniku

--- Kraj citata ---

Posalji Zorteru PP on ti je strucnjak za to!!

medvedicibgd:
Ima u Woby-ju grejalica na plin,sto lici na top,nista glomazno a kazu da dosta dobro greje naravno dok ima plina!!!Ovo mi rekose oni u prodavnici,al probacu da se raspitam kod nekih drugara. :good:

espresso:

--- Citat: maverick  24, 10, 2011, 17:17:53 posle podne ---uzeo sam webasto air top 2000, da li moze biti namontirano u otvorenom dijelu camca, da li mu smeta kisa i vlaga s obzirom da ima elektroniku

--- Kraj citata ---

nisam video niti jedan da je montiran na otvorenom.  siguran sam da o tome nesto pametno pise u uputstvu za instalaciju i rukovanje a evo i sta:

3 Installing Heater Unit
3.1. Choosing installation location
WARNING!
Do not install heater unit and exhaust system in accommodation areas!
(Danger of suffocation in case of improper installation)
• Install the heater unit in a dry location, protected from the ingress of
sea water, excessive vibrations, heat, engine exhaust gasses and soiling
by fuel or oil (requirement from 2001/56/EC).
• Design the installation to suit the requirements and type of boat. Take
the following into account: all peripheral components, such as the
maximum permissible exhaust system length, the position of the onboard
wall ducts, the combustion air intake, the routing of electrical
wiring and cable lengths, the distance from the fuel tank, the routing
of the warm air hoses, the fresh air intake, etc.
• Take the following into account: The maximum inclination of the ship
may not result in the ingress of sea water through the exhaust outlet.
• The inclination may not cause the heater unit to come into contact
with bilge water.
• No obstruction of moving parts (e.g. rudder assembly)!
• Every reasonable precaution should be taken in positioning the heater
to minimise the risk of injury and damage to personal property
CAUION: Heater unit can overheat!
• Ensure sufficient spacing to all parts and sufficient
ventilation!
• Use only fire-resistant materials!
• Install heat shields if necessary!
• Do not install in the vicinity of flammable or
temperature-sensitive objects, such as sails, fenders,
bulkheads, paper, gas lines, fuel containers, etc.
• When installing in locker or control cabinet:
o Only with good ventilation
o Prevent contact with hot parts
o Install a contact barrier around the heating system if
necessary!

ako treba kopija uputstva imam u pdf formatu velicine oko 5Mb pa mogu da posaljem na mail

Navigacija

[0] Indeks poruka

[#] Sledeća strana

[*] Prethodna strana